Emerson LMS1000 User Manual

Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 2-28 Chapter 2. Operating LMS1000
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
USING INFORMATION PAGES
Three user programmable information pages (or screens) can be entered in the system.
These information pages can be viewed by any user through the system command INFO.
Each information page can hold up to 20 lines of text, with 79 characters per line.
Spaces and punctuation each count as a character. These pages can serve as a note
pad or location of instructions for users.
Command SET INFO: The information pages can be created or changed by using the
command SET INFO. This command is available to users programmed for access to
level 6 commands.
USING THE MAIL SERVICE
Each of the eight users has the capability of sending mail to all configured users,
including themselves. When a user logs onto the system, he is notified if there is any
mail sent to him. The user can read his mail by entering the command MAIL. After
displaying the contents of the mail from a particular user, the system asks whether to
save or delete this information. If the mail is not deleted, the user will be notified that he
has mail every time he logs on to the system, or until the sender deletes the mail himself.
After the currently displayed mail is either saved or deleted, mail sent from another user,
if present, is displayed. The users ability to send mail to himself allows the user to write a
message that he will receive every time he logs on to the system. A user can only send
one mail message at a time
Reading Mail: Mail can be read by entering the command MAIL.
Sending Mail: Three lines of information can be created or changed for mailing
purposes by using the command SET MAIL as described in "Chapter 3. Commands".
Each line is 79 characters long. The sender programs which users are to receive his mail
by individually entering the desired user(s) number(s) when prompted. The sender can
also review the mail he previously sent, and at the same time he will be notified by the
system of the users that have acknowledged receiving the mail. This command is
available to users programmed for access to level 1 commands. Use CTRL-R and
CTRL-Z to edit mail messages. Typing CTRL-R copies the previously entered message.
Typing CTRL-Z copies the next character of the previously entered message.

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English