User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-349
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
RETRIEVE-EXTERNAL-CONTROL
(RTRV-EXT-CONT)
Referenced In: TR-NWT-000833, Issue 5; pg. 4-279
General Description: Instructs LMS1000 to retrieve the state of the specified LMS1000
relay channels controlling external controls.
Related Commands: OPERATE-EXTERNAL-CONTROL, RELEASE-EXTERNAL-
CONTROL
LMS1000 Access Level: 1
LMS1000 Equivalent: None
LMS1000 Input Format Variations:
<aid>
Specifying a value of ALL for the access identifier (<aid>) parameter requests the
retrieval of all external control states specified by the control type (<conttype>)
parameter. A NULL value is not permitted for this parameter. Invalid values received for
this parameter return an error response with the error code IIAC.
<conttype>
The control type (<conttype>) parameter is an attribute of the LMS1000 relay channel
configuration. A NULL value requests retrieval of all LMS1000 relay channel states
identified by the access identifier (<aid>) parameter. When the access identifier (<aid>)
parameter is ALL, the control type (<conttype>) parameter should not be NULL. Invalid
values received for this parameter return an error response with the error code IDNV.
LMS1000 Response Format Variations:
<aid>
Identifies the external control for which the state is being retrieved.
<conttype>
This is the control type parameter associated with the LMS1000 relay channel. Values
are derived from the CONTROL TYPE attribute of the LMS1000 relay channel
configuration.
<dur>
This is the duration for which an LMS1000 relay channel is to be activated.
Valid values for the <dur> parameter are as follows:
CONTS Continuous
LMS1000 does not support the value of MNTRY for this parameter.
To Next Page
Loading...
Need help?
General
