Emerson LMS1000 User Manual

Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-118 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
OPTIONS
Description: Lists all available options, and indicates which options are currently
installed in the system. Also shows the port assigned to the option, if applicable.
Command Level: 2
Syntax: OPTION
O
Comments: "Status" parameters include installed/not installed which indicates if the
option is or is not installed in your system, enabled/disabled which indicates if all system
resources required for the option to operate properly are or are not available (disabled
may also be shown to indicate if the option has been deactivated by a user via a
command, if available), and hardware failure which indicates a hardware resource
required by the option has been diagnosed as failed. The "Port Assigned" parameters
include RS-232, OEM1, OEM2, Vortex, and Internal. This parameter gives the
designation of the serial communications port assigned to this option during option
installation. These designations match the silkscreening on the system cabinet with the
exception of the "internal" port, which is inside the cabinet.
Notes: none
Related Commands: none
Example:
Command<6>: options
SYSTEM OPTIONS AS OF 14:15:15 ON 12/10/03.
Option Name Status Port Assigned
----------- ------ -------------
Local Port installed,enabled RS-232 Port
Modem Port installed,enabled Internal Port
Vortex Port not installed
TL1/X.25 not installed
TL1 Over Telnet not installed
LPS Port installed,enabled OEM2 Port
External Modem not installed
AC Analyzer not installed
Front Panel Display not installed
AC & Diesel Sequencers not installed
Energy Management installed,enabled Not Required
Power Metering installed,enabled Not Required
SNMP not installed Ethernet
Web Interface installed,enabled Ethernet
Door Access Controller not installed
Gateway Port installed,enabled OEM1

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English