Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-116 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
NODE REPLACE
Description: Replaces nodes in the database with a new node found on the network.
Command Level: 6
Syntax: NODE REPLACE [node_number]
NO RE [node_number]
Comments: If no modifier is used when entering the command, the system lists all
nodes by Node#, Name, Spec. Number, Ser.# (serial number), Loc (location), and
Echelon Id #. The system then prompts the user to select a node to be replaced. You
select the node by entering the Node# from the list. Note that the node numbers for
unmapped nodes (nodes that were not previously configured) are temporarily listed as
X01 through X99 for reference. The node selected is deleted. If a node that was
previously configured is deleted, the user may also delete the node’s channels. The
system then searches for new nodes on the network and then lists all nodes (new and
old). The user is prompted to enter the name of the node which is to replace the node
deleted.
Notes: Use of this command generates an entry in the Event Log. This cancels any
previous node errors. Do not use this command to replace a Node with a different type of
Node. To replace a Node with a different type of Node first delete the Node using the
command NODE DELETE, then add the new Node using the command ADD NODE.
The Main Cabinet, VPS MCA Interface, and LPS MCA Interface Nodes cannot be
replaced.
"IO network is running." is displayed when the network is ready. The follow are displayed
if the network is not ready.
"IO network is adding nodes.
IO network commands not ready!"
Indicates a new IO network is being discovered.
"IO network is verifying nodes.
IO network commands not ready!"
Indicates a known network is being verified.
"IO network is failed.
IO network commands not ready!"
Indicates an IO network has failed and no communication to nodes is possible.
"IO network is not initialized.
IO network commands not ready!"
Only displayed for a very short time after a reset.
"IO network state is undefined!
IO network commands not ready!"
Only displayed for a very short time after a reset on a new system.
Related Commands: NODE ADD, NODE CONFIG, NODE DELETE, NODE LIST
Example:
Command<6>: NODE REPLACE
To Next Page
Loading...
Need help?
General
