User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-167
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET GATEWAY
Description: Displays the LMS1000 Gateway port's communications parameters and
alliws the data rate to be changed.
Command Level: 6
Syntax: SET GATEWAY
Comments: When this command is entered, the current communications
parameters of the Gateway port are displayed in the following order. Data Rate,
Parity, Data Bits, Stop Bits. Enter a new data rate value or press the ENTER key to
exit the command. If no new data rate was entered, the existing setting is saved.
Available data rates are 300, 1200, 2400, 9600, 19200 bps (default is 9600 bps).
Notes: If a local terminal is being used, the change takes effect immediately. If a remote
terminal (modem) is being used, the change takes effect the next time the modem is
used.
This command lets the user set the Gateway port data rate only. The other
communication parameters are fixed in software, and cannot be changed.
Possible data loss may occur if the LMS1000 Gateway port data rate does not matched
that of the local or remote terminal being used to access the customer equipment via
LMS1000.
The following message is recorded in the event log after successfully changing the
Gateway port’s data rate:
Gateway port configured
Related Commands: CONNECT
Example:
Command<6>: SET GATEWAY
GATEWAY Port Setup: 2400,n,8,1
Enter New Setup: xxxxx
GATEWAY Port Setup: xxxxx,n,8,1
or
ERROR: Invalid Parameter. Port setting not changed
Command<6>:
If the Gateway port is in use by another User, the requesting User is prompted as follows:
Unable to change settings – port in use by another user.
To Next Page
Loading...
Need help?
General
