Emerson LMS1000 User Manual

User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-309
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
TRAPS PERSISTENT
Description: Disable/Enable the systems ability to send SNMP Persistent Alarm TRAPS
or set the Persistent Alarms reporting interval.
Command Level: 6
Syntax: TRAPS PERSISTENT OFF
TRAPS PERSISTENT ON
TRAPS PERSISTENT {period}
Comments: This enables the system to send or disables the system from sending
Persistent Alarms TRAPS. If Persistent Alarms traps are disabled, no Persistent Alarms
will be sent under any circumstances.
{period} must be in the range
1 ≤ {period} ≤ 1440
where period represents the number of minutes between successive traps for a given
channel.
Notes: If TRAPS are disabled altogether via the TRAPS OFF command, Persistent
Alarms TRAPS will not be sent regardless of the setting of the Persistent Alarms TRAPS.
The system default Persistent Alarm period is 20 minutes.
Related Commands: TRAPS
TRAPS ON
TRAPS OFF
Example:
Command<6> : TRAPS PERSISTENT OFF
___________________________________________________________________________________
Command<6> : TRAPS PERSISTENT 20

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English