User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 4. Maintaining LMS1000 Page 4-5
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
ADDING AN INPUT/OUTPUT (I/0) CIRCUIT CARD
Refer to the Installation Instructions (Section 5879) located in the separate
INSTALLATION MANUAL for procedures to do the following. Section 5879 is also
provided on the CD (Electronic Documentation Package) furnished with your system.
• Install the circuit card.
• Wire to the circuit card.
• Configure the associated channels of the circuit card.
Note: When adding or removing a circuit card from the network, the associated Node
must be re-initialized before the network recognizes the addition or removal of the
circuit card. If the Node is not re-initialized, alarms may be present. Re-initialize
the Node to clear the alarms. Note that the configuration for the channels on the
source node may need re-configuring after executing the NODE INITIO
command. Refer to the "NODE INITIO" command in the Commands chapter.
ADDING A MODEM CIRCUIT CARD
Refer to the Installation Instructions (Section 5879) located in the separate
INSTALLATION MANUAL for procedures to do the following. Section 5879 is also
provided on the CD (Electronic Documentation Package) furnished with your system.
• Install the circuit card.
• Connect the phone line.
• Configure modem parameters.
To Next Page
Loading...
Need help?
General
