Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-178 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET LPS MESSAGE CANIO_BD
Description: Sets the Custom Text Message for the selected LPS MCA CAN I/O circuit
card. This message appears in the inventory list during execution of the PRCONFIG LPS
command. A user can also view the Custom Text Message from the MCA display panel
whenever the i (information available) symbol appears in the display. Refer to the LPS
System documentation.
Command Level: 6
Syntax: SET LPS MESSAGE CANIO_BD
SE LP ME CA
Comments: The current message is displayed, followed by a prompt to enter a new
message.
Notes: The custom message can be 20 characters, maximum.
Related Commands: none
Example:
Command<6>: set lps message canio_bd
Which CAN I/O board (bay#-board#)? 01-01
CAN I/O board 01-01 not found!
___________________________________________________________________________________
Command<6>: set lps message canio_bd
Which CAN I/O board (bay#-board#)? 01-04
Which message?
Enter 0 for CAN I/O board or 1-6 for individual I/O # 1
Note: 1 - Binary Input #1, 2 - Binary Input #2, 3 - Binary Input #3,
4 - Binary Input # 4, 5 - Shunt Input, 6 - Shunt Output
Custom message: This is the Analog Input!!!!!!!!
Custom message:
Custom message NOT CHANGED!
___________________________________________________________________________________
Command<6>: set lps message canio_bd
Which CAN I/O board (bay#-board#)? 04-03
Which message?
Enter 0 for CAN I/O board or 1-6 for individual I/O # 0
Custom message: This is CAN I/O board in loc 4-3
Custom message:
Custom message NOT CHANGED!