Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-240 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET VORTEX
Description: Lists all Vortex Interface commands that begin with the command SET,
and then prompts the user to enter one of the displayed options.
Command Level: NA
Syntax: SET VORTEX [command]
SE V [command]
Comments: none
Notes: Only commands available to the current user are listed. The list in the example
is for a user that has access to level 6 commands.
Related Commands: SET
Example:
Command<6>: SET V
SET what?
SYSTEM SUBSYSTEM LVD PCU MESSAGE
PASSWORD INTERFACE
?
___________________________________________________________________________________
Command<6>: SET V SYSTEM
What System parameter:
FLTVOLT TSTEQVOLT HVS CURLIMIT CALVOLT
NAGTIMER TEMPCOMP MODE HIVLTALM1 HIVLTALM2
50%BATONDISCH BATONDISCH OVRCURRENT 25APLACES 50APLACES
100APLACES 200APLACES INVENTORY FACTORYCAL
?
___________________________________________________________________________________
Command<6>: SET V SUBSYSTEM
What Subsystem parameter:
HIVALM LVALM OVRCURRENT CALVOLT FACTORYCAL
?
___________________________________________________________________________________
Command<6>: SET V LVD
What LVD setting:
RECONNECT DISCONNECT
?DISCONNECT
Which LVD PANEL(1-3)?1
Which LVD circuit(A or B)?A
___________________________________________________________________________________
Command<6>: SET V PCU
Which PCU(1-56)?
___________________________________________________________________________________
Command<6>: SET V MESSAGE
Which custom message:
PCU MCA
To Next Page
Loading...
Need help?
General
