Emerson LMS1000 User Manual

Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-174 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET LPS
Description: Lists all LPS MCA Interface commands that begin with the command SET,
and then prompts the user to enter one of the displayed options.
Command Level: NA
Syntax: SET LPS [command]
SE LP [command]
Comments: none
Notes: Only commands available to the current user are listed. The list in the example
is for a user that has access to level 6 commands.
Related Commands: SET, SET VORTEX
Example:
Command<6>: set lps
Set What:
SYSTEM PCU MESSAGE PASSWORD CANIO
? sys
What system parameter:
FLTVOLT TSTEQVOLT HVS CURLIMIT HIVLTALM1
HIVLTALM2 BATONDISCH VERYLOWVOLT LOADCURRENT LOADACURRENT
LOADBCURRENT TSTEQMODE NAGTIMER TSTEQTIME TEMPSLOPE
TEMPCOMPMAX TEMPCOMPMIN HI1TEMPALM HI2TEMPALM LOW1TEMPALM
LOW2TEMPALM RLYTSTTIME RLYONTEST RLYOFFTEST USECELSIUS
USEFAHRENHEIT EQMULTIPLIER UPDATEINV
? flt
Float Voltage: 52.08 VDC
Float Voltage: 52.1
New Float Voltage Accepted.
___________________________________________________________________________________
Command<6>: set lps
Set What:
SYSTEM PCU MESSAGE PASSWORD CANIO
? pcu
Which PCU (bay#-pcu#)? 01-01
Turn PCU 01-01 ON or OFF? off
PCU 01-01 set OFF

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English