Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-84 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
HELP
Description: Lists all commands that are available at the current level with a brief
description (including any programmable commands).
Command Level: NA
Syntax: HELP
H
Comments: Only commands available to the current user are listed. The list in the
example is for a user that has access to level 6 commands.
Notes: The commands preface by the words CLEAR and SET can be viewed by
entering the respective word followed by a question mark.
Programmable commands are also displayed, along with the command string in the
definition column of the help command.
Energy management commands will not be shown if the option is not installed.
To view the help definition for a single command, enter the command followed by a
space then a question mark.
Related Commands: HELP VORTEX, MENU
Example:
Command<6>: help
ACK acknowledge report type alarms
ACO list alarms that have been cutoff
AID <n> display configured access identifiers
ALARMS list active alarms
ANSWER show number of rings before the system answers
BATTERY BATTERY type commands
BOARDS list boards installed in the System Network
BYE logoff and hang-up
CHANNELS list user defined channels
CLASS list programmable alarm classifications
CLR list CLR type commands
CMD list programmable commands
COM list local comm port settings
CONFIG <tn> configure specified channel
CONNECT initiate a communications session
with device connected to GATEWAY port
DATE show date and time
DOWNLOAD dump system configuration using XMODEM Protocol
DOWNLOAD TFTP performs a DUMP operation using TFTP
EFF show Energy Management status
EVENTS <n> list event log entries for specified user
INFO <n> show information pages
IP display the IP Network variables
LIMITS list channel alarm limits
LOG list alarm log entries
MAIL show any mail
MENU list of commands
To Next Page
Loading...
Need help?
General
