Emerson LMS1000 User Manual

User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-17
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
TL1 Commands Supported
This section provides an alphabetical list of all TL1 commands supported when the TL1
software option is installed, with a short description of each command.
Refer to the current issue of the following Bellcore publications for further TL1 command
language information.
TR-NWT-000199 TR-NWT-000835 TA-NWT-001360
TR-NWT-000831 TA-NWT-000199
TR-NWT-000833 TA-NWT-000200
TL1 Commands Supported Description
ACTIVATE-USER
ACT-USER
Sets up a session with the system (i.e., logging into the
system.
ALLOW-MESSAGE-ALL
ALW-MSG-ALL
Enables the system to resume transmission of automatic
messages after being placed in the inhibit message mode.
CANCEL-USER
CANC-USER
Terminates a session with the system (i.e., logging off of the
system).
DELETE-USER-SECURITY
DLT-USER-SECU
Deactivates a user.
EDIT-DATE_AND_TIME
ED-DAT
Changes the system’s date and/or time.
EDIT-PID
ED-PID
Edits the current user’s privilege identifier (<pid>) parameter
(i.e., the system's user password).
EDIT-USER-SECURITY
ED-USER-SECU
Edits the user identifier (<uid>) parameter (i.e., user name),
privilege identifier (<pid>) parameter (i.e., the password),
calling identifier (<cid>) parameter (i.e., user primary phone
number), and user access privilege (<uap>) parameter (i.e.,
user access level) of the specified user.
ENTER-USER-SECURITY
ENT-USER-SECU
Activates a user and enters the specified security parameters
for this user. These security parameters consist of the user
identifier (<uid>) parameter (i.e., user name), privilege
identifier (<pid>) parameter (i.e., user password), calling
identifier (<cid>) parameter (i.e., user primary phone number),
and user access privilege (<uap>) parameter (i.e., user
access level).
INHIBIT-MESSAGE-ALL
INH-MSG-ALL
Disables the transmission of automatic messages.
INITIALIZE-LOG
INIT-LOG
Instructs the system to initialize (i.e., clear) the specified log
(alarm or event).
INITIALIZE-REGISTER
INIT-REG-{EQPT|ALL}
Instructs the system to initialize to a specific value one or
more storage registers or event counters associated with one
or more equipment units, facilities, etc. within the system.
INITIALIZE SYSTEM
INIT-SYS
Instructs the system to initialize its system processor and/or
associated subsystems.
OPERATE-ALARM CUTOFF
OPR-ACO-{EQPT|ALL}
Cuts off the office audible alarm indications without changing
the local alarm indications.
OPERATE-EXTERNAL-CONTROL
OPR-EXT-CONT
Instructs the system to activate a specified relay channel to
operate an external control.

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English