Emerson LMS1000 User Manual

User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 2. Operating LMS1000 Page 2-17
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
USING PROGRAMMABLE COMMANDS
Eight user programmable commands can be entered in the system. A programmable
command combines up to eight standard commands into a single command which then
can be executed by typing the name given the programmable command. The
programmable commands can be created or changed by using the command SET CMD.
This command is described below. The name of the programmable command and the
necessary access level required to execute the command can also be entered or revised
through this command. This command is available to users programmed for access to
level 6 commands.
SET CMD Command: This command lists each item that can be changed, showing the
current information, and then prompting for new or revised information to be entered. If
the current information does not need to be changed, press ENTER to continue.
SET CMD
Command <6>: SET CMD
Type SET CMD, then press ENTER.
Which Command (1 - 8):
Type the number (1-8) which corresponds to
the programmable command configuration
which is to be created or revised, then press
ENTER.
Command _ Name:
Type the desired name for this programmable
command (30 characters maximum), then
press ENTER.
Command _ access level:
Type the desired access level (1-6) required
to execute this programmable command, then
press ENTER.
Command _ line 1:
Note: This line is repeated to enter
up to seven more commands.
Type the first standard command plus any
additional characters to be used with the
standard command (20 characters maximum)
that will be executed when this programmable
command is entered, then press ENTER.

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English