Section 5847 User Instructions
Issue AL, July 24, 2006 Spec. Nos. 586505000 and 5865055000 (Model LMS1000)
Page 3-202 Chapter 3. Commands
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET LPS SYSTEM RLYONTEST
Description: Sets the LPS "alarm relay test feature" on.
Command Level: 6
Syntax: SET LPS SYSTEM RLYONTEST
SE LP SY RLYON
Comments: The current state is displayed, followed by a prompt to change the state.
Notes: The following message is displayed if the setting was not accepted by the MCA.
Not Accepted!
Related Commands: none
Example:
Command<6>: set lps sys rlyon
Relay test is inactive.
Start Relay Function Test? (Y or N): y
Relay Test Started!
___________________________________________________________________________________
Command<6>: set lps sys rlyon
Relay test is active.
Start Relay Function Test? (Y or N): n
Command NOT ACCEPTED!
To Next Page
Loading...
Need help?
General
