Emerson LMS1000 User Manual

User Instructions Section 5847
Spec. Nos. 586505000 and 5865055000 (Model LMS1000) Issue AL, July 24, 2006
Chapter 3. Commands Page 3-361
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
SET-ATTRIBUTE-ENVIRONMENT
(SET-ATTR-ENV)
Referenced In: TR-NWT-000833, Issue 5; pg. 4-395
General Description: Instructs LMS1000 to set the current attributes associated with
the specified environmental alarm.
An entry is made in the LMS1000’s event log indicating this command was executed by
the current user.
Related Commands: RETRIEVE-ATTRIBUTE-ENVIRONMENT
LMS1000 Access Level: 6
An error response with the error code PICC is returned if this command is entered by a
valid user whose level of access is less than the access level of this command.
LMS1000 Equivalent: None
LMS1000 Input Format Variations:
<aid>
The access identifier (<aid>) parameter identifies equipment associated with the
environmental alarm for which attributes are being set. A NULL value is not permitted for
this parameter. Invalid values received for this parameter return an error response with
the error code IIAC.
<ntfcncde>
Specifies the value for the notification code parameter associated with the environmental
alarm conditions being set. Parameter grouping cannot be used with this parameter.
This parameter is an attribute of the LMS1000 channel or limit configuration and is
required in the input.
Valid values for this parameter are as follows:
CR critical alarm
MJ major alarm
MN minor alarm
NULL leaves <ntfcncde> unchanged
Invalid values for this parameter return an error response with the error code IDNV.
<almtype>
Specifies the alarm type parameter associated with the attribute being set. Parameter
grouping cannot be used with this parameter. Values are derived from the CONDITION
TYPE attribute of the LMS1000 channel or limit configuration. This parameter is required
in the command input. The error code for an invalid value for this parameter is IDNV.
<almmsg>

Emerson LMS1000 Specifications

General

Brand	Emerson
Model	LMS1000
Category	Measuring Instruments
Language	English