Parameter Value
Bearing
service
VoIP
Enabling
status
Implement
VPI/VCI Set the VPI/VCI to the same as that configured on the devices
at the central office. In this example, set this parameter to
0/35.
VLAN mode VLAN Transparent Transmission
VLAN ID VLAN ID corresponding to the user VLAN value for voice
service flows created on the ONU. In this example, set this
parameter to 200.
802.1p Enabled
Mode Route mode
DHCP Enabled
NAT Enabled
c. Click OK.
d. Choose Appliciation > Broadband Phone Configuration from the navigation
tree. Configure the parameters as follows:
Parameter Value
Address Preferred IP address of the proxy server: 200.200.200.200
Port ID Preferred signaling port ID of the proxy server: 5060
Enabling Enabled
User number When logging in to a VoIP account, you can set the user
account to the user telephone number. In this example, set
the user telephone number to 83110001.
User
password
-
3. Restart the HGW.
Choose Management > Device Management and click Restarting the Device.
----End
11.4.2.12 Verifying Services
This topic describes how to verify services such as Internet access and IPTV services.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
11 FTTB and FTTC Solution Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1069
To Next Page
Loading...
Need help?
General
