sippstnuser attribute set 0/2/0 priority cat2
sippstnuser auth set 0/2/0 telno 83110000 password-mode password
sippstnuser batadd 0/3/0 0/3/63 0 telno 88110000
sippstnuser attribute batset 0/3/0 0/3/63 potslinetype PayPhone
quit
Configure the polarity reversal accounting function.
pstnport
pstnport attribute batset 0/3/0 0/3/63 reverse-pole-pulse enable
quit
Save the data.
save
3.3.4 Example: Configuring the VoIP Service (H.248-based and SIP-
based)
This topic describes an example for configuring the H.248-based and SIP-based VoIP service.
The MA5600T/MA5603T/MA5608T supports the H.248-based VoIP service and the SIP-based
VoIP service at the same time.
Service Requirements
l The MA5600T/MA5603T/MA5608T upstream to NGN network for ISDN service by
adopting the H.248 protocol. The MA5600T/MA5603T/MA5608T upstream to IMS
network for PSTN service by adopting the SIP protocol.
l ISDN Phone A is connected to the MA5600T/MA5603T/MA5608T through the NT1, and
the ISDN digital phone supports the P2P function.
l Basic rate interface (BRI) is adopted between the NT1 and the MA5600T/MA5603T/
MA5608T to provide a rate of 144 kbit/s, including two B channels and one D channel.
l The Phone B and Phone C are PSTN users, the user priority is Cat2.
l After the configuration is completed, normal calls can be made between two phone sets.
Figure 3-12 shows an example network of the VoIP service that based the SIP protocol and H.
248 protocol.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 3 Configuring the DSLAM Services
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
323
To Next Page
Loading...
Need help?
General
