EasyManuals Logo
Home>Huawei>Control Unit>SmartAX MA5600T

Huawei SmartAX MA5600T User Manual

Huawei SmartAX MA5600T
1979 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #730 background imageLoading...
Page #730 background image
OLT. Select one of them based on site requirements. For details, see the
pitp command.
– The port level: In global config mode, run the pitp port or pitp board
command to enable PITP at the port level.
– The VLAN level:
a. In global config mode, run the vlan service-profile command to create
a VLAN service profile.
b. Run the pitp enable command to enable PITP at the VLAN level.
c. Run the commit command to make the profile configuration take effect.
d. Run the quit command to quit the VLAN service profile mode.
e. Run the vlan bind service-profile command to bind the created VLAN
service profile to a VLAN.
– The service port level: In global config mode, run the pitp service-port
command to enable PITP at the service port level.
2. On the OLT, run the pitp permit-forwarding service-port command with the
enable parameter selected, to allow ONT PPPoE packets to carry a vendor tag.
----End
9.7.3.12 Verifying Services
In the FTTH scenario, ONTs are installed in users' houses which are far away from the central
equipment room. ONTs provide remote service verification methods including PPPoE dialup
emulation, call emulation, and multicast emulation to facilitate configuration and commissioning
engineers to verify services remotely after service configuration.
Prerequisites
ONTs and upper-layer devices have been connected properly. The BRAS and MGC/IMS have
been configured.
Background
Remote
Service
Verificati
on
Method
Function Description
PPPoE
dialup
emulation
An ONT simulates a PPPoE user
terminal software to perform
dialup and interact with the BRAS
to verify the connectivity between
the ONT and BRAS.
l PPPoE dialup emulation requires a
service flow which does not belong to
a QinQ VLAN.
l A user name, password, and
authentication mode must be
configured on the BRAS for the PPPoE
dialup emulation.
l An ONT supports a maximum of a
PPPoE dialup emulation.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 9 FTTH Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
705

Table of Contents

Other manuals for Huawei SmartAX MA5600T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei SmartAX MA5600T and is the answer not in the manual?

Huawei SmartAX MA5600T Specifications

General IconGeneral
BrandHuawei
ModelSmartAX MA5600T
CategoryControl Unit
LanguageEnglish

Related product manuals