1. Configure an S-VLAN.
VLAN 50 is the S-VLAN that functions between the OLT and the MA5633. The OLT
works in Layer 3 forwarding mode.
OLT(config)#vlan 50 smart
OLT(config)#port vlan 50 0/5 0
2. Configure a service flow.
l Configuration of a service flow:
– Service flow ID: 3
– S-VLAN ID: 50
– Customer VLAN (C-VLAN) ID: 50
l Device where upstream and downstream packet rates are limited: MA5633 (In this case,
use the default traffic profile with ID 6, which does not limit the rate of a service flow.
To limit packet rates, run the traffic table ip command to create a traffic profile and
bind it to the service flow.)
Configuration if the service is accessed using a GPON board:
OLT(config)#service-port 3 vlan 50 gpon 0/3/0 ont 1 gemport 1 multi-service
user-vlan 50 rx-cttr 6 tx-cttr 6
Configuration if the service is accessed using a GE board:
OLT(config)#service-port 3 vlan 50 eth 0/3/0 multi-service
user-vlan 50 rx-cttr 6 tx-cttr 6
16.3.1.13 Configuring the BTV Service
A cable modem (CM) connects to a distributed cable modem termination system (D-CMTS)
through a cable and provides the multicast service for users.
Context
All home services use a service VLAN (S-VLAN) and the S-VLAN is globally configured. If
the S-VLAN has been configured for other home services, use the S-VLAN for the multicast
service.
Data Plan
Table 16-14 Data plan for the multicast service
Item Data
VLAN ID of the multicast S-VLAN: 100; type of the VLAN: smart
Uplink ports 0/0/1
Procedure
Step 1 Log in to and configure the ONU.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1703
To Next Page
Loading...
Need help?
General
