EasyManuals Logo
Home>Huawei>Control Unit>SmartAX MA5600T

Huawei SmartAX MA5600T User Manual

Huawei SmartAX MA5600T
1979 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #188 background imageLoading...
Page #188 background image
The L3 interface IP address is 10.50.1.10/24, and this IP address must be in the same network
segment as the gateway IP address (IP address of the router port that is connected to the
MA5600T/MA5603T/MA5608T).
huawei(config)#interface vlanif 2
huawei(config-if-vlanif2)#ip address 10.50.1.10 255.255.255.0
huawei(config-if-vlanif2)#quit
Step 4 Add a static route.
The destination IP address is 10.10.1.0/24, and the next-hop IP address is gateway IP address
10.50.1.1.
huawei(config)#ip route-static 10.10.1.0 24 10.50.1.1
Step 5 Save the data.
huawei(config)#save
----End
Result
After the MA5600T/MA5603T/MA5608T is interconnected with the router successfully, you
can ping IP address 10.10.1.12 from the MA5600T/MA5603T/MA5608T.
Configuration File
vlan 2 smart
port vlan 2 0/19 0
interface vlanif 2
ip address 10.50.1.10 255.255.255.0
quit
ip route-static 10.10.1.0 24 10.50.1.1
save
1.4.3 Commissioning the Interconnection with the BRAS
This topic describes how to check whether the MA5600T/MA5603T/MA5608T can normally
communicate with the BRAS. Working with the BRAS, the MA5600T/MA5603T/MA5608T
can implement the authentication, accounting, and authorization (AAA) service.
Service Requirements
In the network as shown in Figure 1-72, the service requirements are as follows:
l The MA5600T/MA5603T/MA5608T uses the GIU board for upstream transmission.
l A static route is configured on the MA5600T/MA5603T/MA5608T for communicating
with the BRAS.
l The requirements on the BRAS are as follows:
– According to the authentication and accounting requirements for the users, you need to
perform related configurations on the BRAS. For example, configure the access user
domain (including the authentication scheme, accounting scheme, and authorization
scheme that are bound to the domain) and specify the RADIUS server.
– If the BRAS is used to authenticate users, you need to configure the user name and the
password for each user on the BRAS. If the BRAS is used to allocate IP addresses, you
must configure the corresponding IP address pool on the BRAS.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
1 Commissioning
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
163

Table of Contents

Other manuals for Huawei SmartAX MA5600T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei SmartAX MA5600T and is the answer not in the manual?

Huawei SmartAX MA5600T Specifications

General IconGeneral
BrandHuawei
ModelSmartAX MA5600T
CategoryControl Unit
LanguageEnglish

Related product manuals