Add an ONT to an OLT
Configure the voice
service
Start
Configure Link Aggregation, Congestion
Control, and Security Policy
Configure L3 HSI
service
End
Configure the bridge
WAN multicast service
Verifying Services
Configure the VoD
service
NOTE
Texts in blue show the configuration difference between IPv6 and IPv4.
19.6.4 Configuration Example
Introduce the end-to-end service configuration based on the FTTH (Gateway ONT) networking
and the corresponding data plan.
Key Messages for Configuration
In this example, two ONTs are connected to the same PON port of the OLT. Triple play services
are required
l Even after IPv6 is used, the voice service is still realized by IPv4.
l Even after IPv6 is used, the OLT implement Layer 2 forwarding for HSI service in this
networking, irrespective of whether the access service is IPv4 or IPv6. Service
configurations for IPv4 and IPv6 are the same. For the HSI service from one end user, one
service flow is used to carry IPv6 and IPv4 Internet services, and the same service VLAN
is used. The gateway ONT requires specific configuration to enable the IPv4/IPv6 dual
stack or the DS-Lite for the HSI service.
l For multicast service, the OLT is the node to make multicast duplication. The configuration
procedure is the same for IPv4 multicast and IPv6 multicase. The IPv4 multicast service
and IPv6 multicast service can be configured in the same multicast VLAN on the OLT
equipment.
Data plan on the OLT side
Web or the NMS is recommended to configure the gateway ONT layer 3 HSI service. CLI
through the OLT is recommended to configure the gateway ONT voice service. The WAN
interface for multicast service on the ONT is configured by iTMS.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
19 IPv6 Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1939
To Next Page
Loading...
Need help?
General
