255.255.255.0 gateway
192.168.50.1 vlan 8
huawei(config-if-gpon-0/3)#quit
Step 3 Configure the in-band management service port.
Set the management VLAN to 8, GEM port ID to 11, and user VLAN to 8. The OLT does not
rate limit the in-band management service port. Therefore, directly use the default traffic profile
6.
huawei(config)#service-port vlan 8 gpon 0/3/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 4 Confirm that the connection between the management service ports on the OLT and ONU is
reachable.
l Run the ping ONU ip command on the OLT to verify the connectivity between the OLT and
ONU. If the OLT receives ICMP ECHO-REPLY packets from the ONU, the connection is
reachable.
l When the connection is reachable, you can remote log in to the ONU from the OLT and
configure the ONU.
----End
13.3.5.5 Configuring SAToP Connections and Service Ports
This topic describes how to configure a SAToP connection of the IP+UDP encapsulation type
and a service port to enable packets of enterprise to be encapsulated on ONUs and restored on
OLTs.
Prerequisites
Required hardware is available:
l Main control boards on the OLT: SCUN+CKMC/CKMD
l Upstream board on the OLT: EDTB (for E1 upstream transmission)
l Service board on the OLT: GPBD
l ONU: MA5612 (configured with the E81A board) or MA5628
Context
Figure 13-17 shows SAToP encapsulation for enterprise E1/T1 unified access service. As shown
in the following figure, after TDM signals are encapsulated in the IP+UDP format, an outer
VLAN tag and an Ethernet header are added to the TDM signals. Then the TDM signals become
a standard Ethernet packet that is transmitted on the PON line between the ONU and OLT.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
13 FTTO Configuration (Large-sized Enterprise Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1333
To Next Page
Loading...
Need help?
General
