QoS Planning
The E2E QoS planning includes the flow classification, marking/scheduling policy, traffic
monitoring, and DBA policy.
When the IPv6 protocol is used, the QoS planning is the same for both IPv6 and IPv4.
l Management service: IPv4
l Voice service: IPv4
l IPTV service: One user uses either IPv6 or IPv4 at one time. The QoS planning for IPv6
and IPv4 IPTV services is the same.
l Internet service: It is recommended that devices use one flow to carry IPv6 and IPv4 Internet
services. The QoS planning is the same for the flow that carries both IPv6 and IPv4 Internet
services and the flow that carries only the IPv4 Internet service.
Internet Service Planning
The Internet service planning includes the VLAN and VLAN switching policy planning in
different networking scenarios.
IPv6 and IPv4 Internet services: It is recommended that devices use one flow to carry IPv6 and
IPv4 Internet services. This facilitates the control of the aggregate rate for IPv6 and IPv4 Internet
services. The QoS planning is the same for the flow that carries both IPv6 and IPv4 Internet
services and the flow that carries only the IPv4 Internet service.
Voice Service Data Planning
Voice service data planning includes the VLAN/VLAN switching policy planning in different
networking scenarios, and the voice protocol planning.
When the IPv6 protocol is used, the voice service still uses IPv4 to implement voice services.
IPTV Service Data Planning
IPTV service data planning includes the VLAN/VLAN switching policy planning in different
networking scenarios, and IPTV service planning.
When the IPv6 protocol is used, one IPTV user uses either IPv6 or IPv4 at one time. The VLAN
data planning for IPv6 is consistent with that for IPv4. For details, see 9.6.5 Principle of IPTV
Service Data Plan.
19.5.3 Configuration Procedure
This section describes IPv6 configuration procedure, and compares it with the IPv4 configuration
procedure.
FTTH (Bridging ONT) Configuration Procedure
After IPv6 is introduced to the FTTH (bridging ONT) scenario, the service configuration
procedure is shown in the following figure. When IPv6 is introduced, the configurations for
security features and BTV multicast services on the OLT side are different from those of IPv4.
Other configurations do not change. For differences, see 19.2 Configuration Difference
Between IPv6 and IPv4.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
19 IPv6 Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1919
To Next Page
Loading...
Need help?
General
