[CX600]mpls
[CX600]interface GigabitEthernet 1/0/0.1
[CX600-GigabitEthernet1/0/0.1]mpls
Step 2 Configure the E1 port.
Configure E1 port 2/1/0. Set the working mode to CEL and timeslot 1-15 as a channel.
NOTE
The timeslot on the CX600 must be the same as that on the ONU.
[CX600]controller E1 2/1/0
[CX600-E1 2/1/0]using ce1
[CX600-E1 2/1/0]channel-set 0 timeslot-list 1-15
[CX600-E1 2/1/0]quit
Step 3 Configure the static route to the ONU.
Configure the static route whose destination IP address is the IP address of the E1 board on the
ONU and egress interface is GE sub interface 1/0/0.1.
[CX600]ip route-static 10.0.0.10 32 GigabitEthernet 1/0/0.1 10.0.0.10
Step 4 Configure the CX600 as the ingress node of the static LSP.
[CX600]static-lsp ingress lsp1 destination 10.0.0.10 32 nexthop 10.0.0.10
outgoing-interface GigabitEthernet 1/0/0.1 out-label 8200
Step 5 Configure the CX600 as the egress node of the static LSP.
[CX600]static-lsp egress lsp2 incoming-interface GigabitEthernet 1/0/0.1
in-label 2000
Step 6 Configure the static PW.
[CX600]interface Serial2/1/0:0
[CX600-Serial2/1/0:0]link-protocol tdm
[CX600-Serial2/1/0:0]mpls static-l2vc destination 10.0.0.10 transmit-vpn
-label 8500 receive-vpn-label 8000 rtp-header tdm-encapsulation 8 jitter-buffer 2
----End
14.4.7.6 Configuring Clock Synchronization
In this scenario, network-wide clock synchronization is implemented through synchronous
Ethernet clocks.
Prerequisites
l The clock daughter board CKMC/CKMD of the SCU control board is in position.
l The Ethernet upstream board is the GICK/GSCA (GE port) or X2CS/SPUF (10GE port)
board.
l The upstream MAN PSN of the OLT supports Synchronous Ethernet.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1493
To Next Page
Loading...
Need help?
General
