EasyManuals Logo
Home>Huawei>Control Unit>SmartAX MA5600T

Huawei SmartAX MA5600T User Manual

Huawei SmartAX MA5600T
1979 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1318 background imageLoading...
Page #1318 background image
huawei(config)#service-port vlan 8 gpon 0/3/1 ont 1 gemport 11 multi-service
user-vlan 8 rx-cttr 6 tx-cttr 6
Step 4 Confirm that the connection between the management service ports on the OLT and ONU is
reachable.
l Run the ping ONU ip command on the OLT to verify the connectivity between the OLT and
ONU. If the OLT receives ICMP ECHO-REPLY packets from the ONU, the connection is
reachable.
l When the connection is reachable, you can remote log in to the ONU from the OLT and
configure the ONU.
----End
13.3.2.5 Configuring TDM Connections
This topic describes how to configure Native TDM connections between GPON ports and E1/
STM-1 upstream ports to transmit E1/STM-1 private line service data.
Prerequisites
Required hardware is available:
l TOPA+NH1A for upstream transmission through E1
l TOPA+O2CE for upstream transmission through STM-1
l GPON board: GPBC, GPBD
Context
The OLT can transmit data to the SDH network through E1 or STM-1 lines. Each E1 line provides
2 Mbit/s bandwidth. After being mapped, aligned, and encapsulated, 63xE1 signals are
multiplexed into one STM-1 signal through VC12. One STM-1 line provides 155 Mbit/s.
When the OLT transmits data to SDH equipment through STM-1 lines, pay attention to the VC12
mode and VC12 number.
l When the OLT is interconnected with Huawei SDH equipment, the VC12 mode is huawei
and the VC12 numbers on the OLT and the SDH equipment must be consistent.
l When the OLT is interconnected with Lucent SDH equipment, the VC12 mode is lucent.
The VC12 numbers has the following mapping relationships (which can be queried using
the display vc12-mode-table command):
Huawei: Mapping between the multiplexing number and VC12 number: VC12 number =
(TUG3–1) + (TUG2–1) x 3 + (TU12–1) x 21
Lucent: Mapping between the multiplexing number and VC12 number: VC12 number =
(TU12–1) + (TUG2–1) x 3 + (TUG3–1) x 21
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
13 FTTO Configuration (Large-sized Enterprise Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1293

Table of Contents

Other manuals for Huawei SmartAX MA5600T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei SmartAX MA5600T and is the answer not in the manual?

Huawei SmartAX MA5600T Specifications

General IconGeneral
BrandHuawei
ModelSmartAX MA5600T
CategoryControl Unit
LanguageEnglish

Related product manuals