(Wi-Fi) access for users. This section describes how to configure the optical line terminal (OLT)
to provision the WLAN hotspot radio backhaul service.
Service Requirements
A network supplier needs to provide the Internet access service through Wi-Fi for a business
area covered by APs.
Usage Scenario
As shown in Figure 15-12, a D-CMTS is deployed on an optical node and CMs are deployed
at shops. The CMs connect to RF ports on the D-CMTS through cables.
l A CM connects to wireless APs to provide the WLAN hotspot radio backhaul service. The
wireless APs provide Wi-Fi access for users.
l Wi-Fi users access the Internet through Dynamic Host Configuration Protocol (DHCP)
dialup.
l The D-CMTS works as a GPON remote extended frame. This reduces D-CMTS
management and maintenance costs and simplifies configurations.
Figure 15-12 WLAN hotspot radio backhaul service networking
Configuration
The method of configuring the WLAN hotspot radio backhaul service is the same as that of
configuring the L2VPN enterprise service and therefore is not described in this section. For
details, see 15.3.2.2 Configuration Process.
15.4 Service Configuration on a D-CMTS That Works as a
GE Remote Extended Frame on a Layer 3 Network
This section describes how to configure services, including the Internet access service, voice
service, and VoD service, on an optical line terminal (OLT) when a distributed cable modem
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
15 OptiCable D-CMTS Configuration (MA5633 Working as
a Remote Extended Frame)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1591
To Next Page
Loading...
Need help?
General
