Parameter Value
Mode Route: route mode
DHCP Enabled
NAT Enabled
c. Click OK to save the settings.
d. Choose Appliciation > Broadband Phone Configuration from the navigation
tree. Configure the parameters as follows:
Parameter Value
Address Preferred IP address of the proxy server: 200.200.200.200
Port ID Preferred signaling port ID of the proxy server: 5060
Enabling Enabled
User number When logging in to a VoIP account, you can set the user
account to the user telephone number. In this example, set
the user telephone number to 77730010.
User
password
-
3. Restart the HGW.
Choose Management > Device Management and click Restarting the Device.
----End
10.6.2.7 Configuring the BTV Service
The OLT is connected to the remote bridging ONU through a GPON port to provide users with
the multicast service.
Prerequisites
l The OLT is connected to the BRAS and the multicast source.
l The VLAN of the LAN switch port connected to the OLT is the same as the upstream
VLAN of the OLT.
l The ONU has been added to the OLT. For details, see 10.6.2.3 Adding an ONU to an
OLT.
l A VDSL2 port has been activated. For details, see 10.6.1.4 Configuring a VDSL2 User
Port.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
10 FTTD Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
803
To Next Page
Loading...
Need help?
General
