Parameter Value
VLAN mode VLAN Transparent Transmission
VLAN ID VLAN ID corresponding to the user VLAN value for voice
service flows created on the OLT. In this example, set this
parameter to 47.
802.1p Enabled
Mode Route: route mode
DHCP Enabled
NAT Enabled
c. Click OK to save the settings.
d. Choose Appliciation > Broadband Phone Configuration from the navigation
tree. Configure the parameters as follows:
Parameter Value
Address Preferred IP address of the proxy server: 200.200.200.200
Port ID Preferred signaling port ID of the proxy server: 5060
Enabling Enabled
User number When logging in to a VoIP account, you can set the user
account to the user telephone number. In this example, set
the user telephone number to 77730010.
User
password
-
3. Restart the HGW.
Choose Management > Device Management and click Restarting the Device.
----End
9.7.2.6 Configuring the BTV Service
The OLT is connected to the remote bridging ONT through a GPON port to provide users with
the multicast service.
Prerequisites
l The OLT is connected to the BRAS and the multicast source.
l The VLAN of the LAN switch port connected to the OLT is the same as the upstream
VLAN of the OLT.
l The ONT has been added to the OLT. For details, see 9.7.1.3 Adding an ONT to an
OLT.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
9 FTTH Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
641
To Next Page
Loading...
Need help?
General
