-------------------------------------------------------------------------
-----
Index Board Source Clk-type State Priority QL
Selected
-------------------------------------------------------------------------
-----
0 H801GICK 0/19/0 ETH Normal 0 ---
YES
-------------------------------------------------------------------------
-----
Run the display clock mode command to query the clock working mode. Ensure that
the clock daughter board works in tracing mode.
huawei(config)#display clock mode
Clock manage-mode:Third-mode
Clock subboard work-mode:Tracing
l Configure a clock on the ONU.
The transmit clock of the port is the system clock by default when base stations are
connected to the ONU through ETH ports. The transmit clock cannot be modified.
Therefore, you only need to configure the system clock for the ONU.
1. Configure the PON line clock as the system clock.
huawei(config)#clock source 0 0/0/1
huawei(config)#clock priority system 0
2. Query the configuration and status of the system clock source.
Run the display clock source command to query the configuration and status of the
system clock source.
huawei(config-if-tdm-0/1)#quit
huawei(config)#display clock source
--------------------------------------------------------------------
Index Type Source State Priority QL Selected
--------------------------------------------------------------------
0 line 0/0/1 Normal 0 --- YES
1 -- -/ -/ - --- --- NO ---
2 -- -/ -/ - --- --- NO ---
3 -- -/ -/ - --- --- NO ---
4 -- -/ -/ - --- --- NO ---
5 -- -/ -/ - --- --- NO ---
6 -- -/ -/ - --- --- NO ---
7 -- -/ -/ - --- --- NO ---
8 -- -/ -/ - --- --- NO ---
9 -- -/ -/ - --- --- NO ---
--------------------------------------------------------------------
----End
14.4.3.8 Configuring Congestion Control and Security Policies
This topic describes how to configure global priority-based scheduling policies for queues to
ensure service reliability and configure global security policies to ensure service security.
Context
Congestion control uses queue scheduling technology to map packets sent from the same port
into multiple queues and process packets in each queue based on priority. Congestion control is
recommended.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1443
To Next Page
Loading...
Need help?
General
