Run the display clock source system command to query the configurations and status
of the clock source. Ensure that the configurations of the system clock source are
correct and the status of the system clock source is Normal.
huawei(config)#display clock source system
-------------------------------------------------------------------------
-----
Index Board Source Clk-type State Priority QL
Selected
-------------------------------------------------------------------------
-----
0 H801GICK 0/19/0 ETH Normal 0 ---
YES
-------------------------------------------------------------------------
-----
Run the display clock mode command to query the working mode of the clock. Ensure
that the working mode of the clock daughter board is Tracing.
huawei(config)#display clock mode
Clock manage-mode:Third-mode
Clock subboard work-mode:Tracing
l Configure the ONU-side clock.
1. Configure the PON line clock as the system clock.
huawei(config)#clock source 0 0/0/1
huawei(config)#clock priority system 0
2. Query the configuration and status of the system clock source.
Run the display clock source command to query the configuration and status of the
system clock source.
huawei(config-if-tdm-0/1)#quit
huawei(config)#display clock source
--------------------------------------------------------------------
Index Type Source State Priority QL Selected
--------------------------------------------------------------------
0 line 0/0/1 Normal 0 --- YES
1 -- -/ -/ - --- --- NO ---
2 -- -/ -/ - --- --- NO ---
3 -- -/ -/ - --- --- NO ---
4 -- -/ -/ - --- --- NO ---
5 -- -/ -/ - --- --- NO ---
6 -- -/ -/ - --- --- NO ---
7 -- -/ -/ - --- --- NO ---
8 -- -/ -/ - --- --- NO ---
9 -- -/ -/ - --- --- NO ---
--------------------------------------------------------------------
----End
14.4.4.6 Configuring Congestion Control and Security Policies
This topic describes how to configure global priority-based scheduling policies for queues to
ensure service reliability and configure global security policies to ensure service security.
Context
Congestion control uses queue scheduling technology to map packets sent from the same port
into multiple queues and process packets in each queue based on priority. Congestion control is
recommended.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1458
To Next Page
Loading...
Need help?
General
