Xerox VersaLink B7025 Service Manual

April 2017
2-125
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
016-368, 369, 370, 016-371
Status Indicator RAPs
Launch Issue
016-368, 369, 370 Controller Diagnostic Fail RAP
016-368 Cont torino diagnostic fail.
016-369 Cont S2X board diagnostic fail.
016-370 Cont rendering engine diagnosed as having a failure.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Ensure that all connectors on the ESS PWB, PL 3.10 Item 6 are securely connected.
Ensure all surface mounted modules are securely connected.
3. Reload the software, GP 4.
4. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.
016-371 Controller USB 1.1 Host Fail RAP
016-371 A defect was detected during a diagnostic check of USB 1.1 host (no communication
with the fax card could be established).
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Ensure that all connectors on the fax PWBs, PL 20.05 are securely connected.
3. Reload the software, GP 4.
4. Install new components as necessary:.
•Line 1 fax PWB, PL 20.05 Item 10.
•Line 2 fax PWB, PL 20.05 Item 15.
•Line 3 fax PWB, PL 20.05 Item 15.
5. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.

Xerox VersaLink B7025 Specifications

General

Brand	Xerox
Model	VersaLink B7025
Category	All in One Printer
Language	English