Xerox VersaLink B7025 Service Manual

April 2017
4-98
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
REP 13.5, REP 13.6
Launch Issue
Repairs and Adjustments
4. Undock the finisher, Figure 2:
a. Remove the screw (1).
b. Pull the docking plate lever (2) forwards to detach the finisher.
Figure 2 Finisher undocking
Replacement
1. Align the machine docking bracket with the cut outs in the finisher docking bracket.
2. Mate the finisher to the machine until it latches.
3. Check that the finisher is firmly latched to the machine.
4. Perform the remainder of the replacement procedure in reverse of the removal procedure.
REP 13.6 Front Cover
Parts List on PL 13.10
Removal
WARNING
Switch off the electricity to the machine. Refer to GP 10. Disconnect the power cord
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Undock the finisher, REP 13.5.
CAUTION
Take care not drop the booklet maker thumb screw into the finisher.
2. Remove the booklet maker, REP 13.31.
3. Open the finisher front door, PL 13.10 Item 5.
4. Remove the five screws, then the front cover, PL 13.10 Item 4.
Replacement
The replacement is the reverse of the removal procedure.

Xerox VersaLink B7025 Specifications

General

Brand	Xerox
Model	VersaLink B7025
Category	All in One Printer
Language	English