April 2017
2-536
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
117-330, 117-331, 117-355
Launch Issue
Status Indicator RAPs
117-330 XBDS Soft Fail RAP
117-330 An Ethernet error was detected.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Advise the customer to check whether HTTP and HTTPS have started up normally and
are operable.
3. Advise the customer to check that the TCP/IP ports are correctly configured.
4. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
5. Reload the software, GP 4.
6. Perform the 016A Scan to Network Error Entry RAP.
7. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.
117-331, 117-355 Uninitialized RAP
117-331 An uninitialized HDD that was used for another machine was recognized.
117-355 HDD is not recognized in this startup.
Procedure
Perform the 016-210, 506, 777, 780, 798 HDD Error RAP.
To Next Page
Loading...
Need help?
General
