April 2017
2-563
Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
124-331 to 124-339, 124-340, 360, 390
Status Indicator RAPs
Launch Issue
124-331 to 124-339 ESS ROM DIMM RAP
124-331 The system detected that the ESS ROM DIMM #1 was not installed.
124-333 An error was detected in the Panther.
124-334 An error was detected in the standard built-in font ROM.
124-335 The installation of the font ROM was not detected.
124-337 An error was detected in the ESS built-in standard RAM.
124-338 The system detected that a duplicate font ROM was installed.
124-339 The system detected that the ROM DIMM for another model was installed.
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. Ensure that all connectors on the drive PWB, PL 1.10 Item 3 and the ESS PWB, PL 3.10
Item 6 are securely connected. Ensure all surface mounted modules on both PWBs are
securely connected.
3. Reload the software, GP 4.
4. If the fault persists, install a new ESS PWB, PL 3.10 Item 6.
124-340, 360, 390 CRUM Market Fail All RAP
124-340 The CRUM destinations stored in three positions match but their values are not set
(0).
124-360 The CRUM enable/disable settings stored in three positions match but their values
are not set (0).
124-390 The CRUM OEM destinations stored in three positions match but their values are not
set (0).
Procedure
WARNING
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Switch off, then switch on the machine, GP 10.
2. If the fault persists, install a new drive PWB, PL 1.10 Item 3.
To Next Page
Loading...
Need help?
General
