Rockwell Automation Publication 1783-UM007G-EN-P - February 2017 69
Get Started Chapter 2
With firmware revision 2.001 or later, the firmware is installed to the running
nonvolatile memory location:
• If you start the switch with the SD card inserted, the firmware is
installed on the SD card.
• If you start the switch from internal memory without the SD card
inserted, the firmware is installed in the internal memory.
When the update process completes, a success message appears, and the switch
automatically restarts. It can take a few minutes for the switch to restart with
the new firmware.
Verify that the latest firmware revision on the switch appears in the Software
field in the Switch Information area of the dashboard.
For more information, see the online help for Device Manager.
Cisco Network Assistant
Cisco Network Assistant is a web interface that you download from Cisco’s
website and run on your computer. It offers advanced options for configuring
and monitoring multiple devices, including switches, switch clusters, switch
stacks, routers, and access points.
Follow these steps to use the software.
1. Go to
http://www.cisco.com/go/NetworkAssistant.
You must be a registered user, but you need no other access privileges.
2. Find the Network Assistant installer.
3. Download the Network Assistant installer, and run it.
You can run it directly from the web if your browser offers this choice.
4. When you run the installer, follow the displayed instructions.
5. In the final panel, click Finish to complete the Network Assistant
installation.
For more information, see the online help for Network Assistant.
IMPORTANT Wait for the update process to complete. Do not use or close the browser
session with Device Manager active. Do not access Device Manager from
another browser session.
To Next Page
Loading...
Need help?
General
