Allen-Bradley Stratix 5400 User Manual

Rockwell Automation Publication 1783-UM007G-EN-P - February 2017 97
Chapter 4
Install Stratix 5410 Switches
Topic Page
Switch Specifications 101
Power Supply Specifications 101
Overview 102
Parts List and Required Tools 103
Install or Remove the SD Card 105
Verify Switch Operation 107
Mount the Switch on a Rack 107
Mount the Switch on a Wall 111
Ground the Switch 114
Install a Power Supply Module in the Switch 115
Wire the Power Source 116
Remove a Power Supply Module from the Switch 120
Install an SFP Module 120
Remove an SFP Module from an SFP Slot 122
Wire the External Alarms 123
Attach the Alarm Relay Connector to the Switch 124
Connect to 10/100/1000 Ethernet, PoE/PoE+ Ports 124
Connect to SFP/SFP+ Ports 126
ATTENTION: Environment and Enclosure
This equipment is intended for use in a Pollution Degree 2 industrial environment, in overvoltage Category II applications (as
defined in IEC 60664-1), at altitudes up to 2000 m (6562 ft) without derating.
This equipment is not intended for use in residential environments and may not provide adequate protection to radio
communication services in such environments.
This equipment is supplied as open-type equipment. It must be mounted within an enclosure that is suitably designed for those
specific environmental conditions that will be present and appropriately designed to prevent personal injury resulting from
accessibility to live parts. The enclosure must have suitable flame-retardant properties to prevent or minimize the spread of flame,
complying with a flame spread rating of 5VA or be approved for the application if nonmetallic. The interior of the enclosure must be
accessible only by the use of a tool. Subsequent sections of this publication may contain additional information regarding specific
enclosure type ratings that are required to comply with certain product safety certifications.
In addition to this publication, see the following:
• Industrial Automation Wiring and Grounding Guidelines, publication
1770-4.1, for additional installation requirements
• NEMA Standard 250 and IEC 60529, as applicable, for explanations of the degrees of protection provided by enclosures

Allen-Bradley Stratix 5400 Specifications

General

Brand	Allen-Bradley
Model	Stratix 5400
Category	Switch
Language	English