Version 6.6 489 Mediant 800 MSBR
User's Manual 33. CRP Configuration
33 CRP Configuration
This section describes configuration specific to the CRP application. As CRP has similar
functionality to the SBC application, for configuration common to the SBC, which is not
covered in this section, see the following SBC sections:
Configuring General Settings (see Configuring General Settings on page 457)
Configuring Admission Control (see Configuring Admission Control on page 458)
Configuring Allowed Coder Groups (see Configuring Allowed Coder Groups on page
460)
Configuring Classification Rules (see Configuring Classification Rules on page 462)
Configuring Condition Rules (see Configuring Condition Rules on page 467)
Configuring SBC IP-to-IP Routing (see Configuring SBC IP-to-IP Routing on page
468)
Configuring Alternative Routing Reasons (see Configuring Alternative Routing
Reasons on page 474)
Configuring IP-to-IP Inbound Manipulations (see Configuring IP-to-IP Inbound
Manipulations on page 477)
Configuring IP-to-IP Outbound Manipulations (see Configuring IP-to-IP Outbound
Manipulations on page 480)
Note: The main difference in the common configuration between the CRP and SBC
applications is the navigation menu paths to opening these Web configuration
pages. Wherever "SBC" appears in the menu path, for the CRP application it
appears as "CRP".
33.1 Enabling the CRP Application
The procedure below describes how to enable the CRP application.
Note: For CRP support, the device must be installed with the relevant Software
License Key. This License Key must also be defined with the required number
of call sessions.
To enable the CRP application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
2. From the 'Enable CRP Application' drop-down list, select Enable.
3. Save (burn) the changes to the device's flash memory with a device reset (see Saving
Configuration on 624).
To Next Page
Loading...
Need help?
General
