AudioCodes Media 800 MSBR User Manual

Version 6.6 773 Mediant 800 MSBR
User's Manual 66. Configuration Parameters Reference
Parameter Description

[0] = (Default) Lifeline is activated upon power outage.
 [1] = Lifeline is activated upon power outage.
 [2] = Lifeline is activated upon a power outage, network failure
(logical link disconnection), or when the Trunk Group is in Busy Out
state (see the EnableBusyOut parameter).
The Lifeline (FXS) phone is connected to FXS Port 1. FXS Port 1
connects to the POTS (Lifeline) phone as well as to the PSTN / PBX,
using a splitter cable.
Notes:
 For this parameter to take effect, a device reset is required.
 This parameter is applicable only to FXS interfaces.
 To enable Lifeline upon a network failure, the LAN watch dog must
be activated (i.e., set the parameter EnableLANWatchDog to 1).
 The number of supported Lifelines depends on the device’s
hardware configuration. For the combined FXS/FXO configuration,
one Lifeline is available; for the 12-FXS configuration, up to three
Lifelines are available.
 For information on Lifeline cabling, refer to the Installation Manual.
Web: Delay After Reset
[sec]
CLI: delay-after-reset
[GWAppDelayTime]
Defines the time interval (in seconds) that the device's operation is
delayed after a reset.
The valid range is 0 to 45. The default is 7 seconds.
Note: This feature helps overcome connection problems caused by
some LAN routers or IP configuration parameters' modifications by a
DHCP server.
[EnableAutoRAITransmi
tBER]
Enables the device to send a remote alarm indication (RAI) when the bit
error rate (BER) is greater than 0.001.
 [0] Disable (default)
 [1] Enable
Web: Ignore BRI LOS
Alarm
CLI: ignore-bri-los-alarm
[IgnoreBRILOSAlarm]
Enables the device to ignore LOS alarms received from the BRI user-
side trunk and attempts to make a call (relevant for IP-to-Tel calls).
 [0] Disable
 [1] Enable (default)
66.3.2 SIP Test Call Parameters
The SIP Signaling Test Call parameters are described in the table below.
SIP Test Call Parameters
Parameter Description
Web: Test Call DTMF
String
CLI:testcall-dtmf-string
[TestCallDtmfString]
Defines the DTMF tone that is played for answered test calls (incoming
and outgoing).
The DTMF string can be up to 15 strings. The default is "3212333". An
empty string means that no DTMF is played.
Web: Test Call ID
CLI: testcall-id
[TestCallID]
Defines the test call prefix number (ID) of the simulated phone on the
device. Incoming calls received with this called prefix number are
identified as test calls.
This can be any string of up to 15 characters. By default, no number is

AudioCodes Media 800 MSBR Specifications

General

Brand	AudioCodes
Model	Media 800 MSBR
Category	Network Router
Language	English