Parameter Description
TelProfile_Enable911P
SAP
Enable 911 PSAP Enable911PSAP
TelProfile_SwapTelToIp
PhoneNumbers
Swap Tel To IP Phone
Numbers
SwapTEl2IPCalled&Cal
lingNumbers
TelProfile_EnableAGC Enable AGC EnableAGC
TelProfile_ECNlpMode EC NLP Mode ECNLPMode
TelProfile_DigitalCutThr
ough
- DigitalCutThrough
TelProfile_EnableFXOD
oubleAnswer
- EnableFXODoubleAns
wer
TelProfile_CallPriorityM
ode
- CallPriorityMode
66.10 Channel Parameters
This subsection describes the device's channel parameters.
66.10.1 Voice Parameters
The voice parameters are described in the table below.
Voice Parameters
Parameter Description
Web/EMS: Input Gain
CLI: input-gain
[InputGain]
Defines the pulse-code modulation (PCM) input gain control (in
decibels). This parameter sets the level for the received
(Tel/PSTN-to-IP) signal.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: This parameter can also be configured in an IP Profile
and/or a Tel Profile.
Web: Voice Volume
EMS: Volume (dB)
CLI: voice-volume
[VoiceVolume]
Defines the voice gain control (in decibels). This parameter sets
the level for the transmitted (IP-to-Tel/PSTN) signal.
The valid range is -32 to 31 dB. The default is 0 dB.
Note: This parameter can also be configured in an IP Profile
and/or a Tel Profile.
EMS: Payload Format
CLI: G726-voice-payload-format
[VoicePayloadFormat]
Determines the bit ordering of the G.726/G.727 voice payload
format.
 [0] = (Default) Little Endian
 [1] = Big Endian
Note: To ensure high voice quality when using G.726/G.727, both
communicating ends should use the same endianness format.
Therefore, when the device communicates with a third-party entity
that uses the G.726/G.727 voice coder and voice quality is poor,
change the settings of this parameter (between Big Endian and
Little Endian).
Web: MF Transport Type
CLI: MF-transport-type
[MFTransportType]
Currently, not supported.
To Next Page
Loading...
Need help?
General
