66 Configuration Parameters Reference
The device's VoIP functionality (not data-routing functionality) configuration parameters,
default values, and their descriptions are documented in this section.
Notes: Parameters and values enclosed in square brackets [...] represent the ini file
parameters and their enumeration values.
66.1 Networking Parameters
This subsection describes the device's networking parameters.
66.1.1 Multiple VoIP Network Interfaces and VLAN Parameters
The IP network interfaces and VLAN parameters are described in the table below.
IP Network Interfaces and VLAN Parameters
Parameter Description
Multiple Interface Table
Web: Multiple Interface
Table
EMS: IP Interface
Settings
CLI: configure voip >
interface network-if
display
[InterfaceTable]
This table parameter configures the Multiple Interface table. The format
of this parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index = InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName,
InterfaceTable_PrimaryDNSServerIPAddress,
InterfaceTable_SecondaryDNSServerIPAddress,
InterfaceTable_UnderlyingInterface;
[\InterfaceTable]
For example:
InterfaceTable 0 = 0, 0, 192.168.85.14, 16, 0.0.0.0, 1, Management;
InterfaceTable 1 = 2, 0, 200.200.85.14, 24, 0.0.0.0, 200, Control;
InterfaceTable 2 = 1, 0, 211.211.85.14, 24, 211.211.85.1, 211, Media;
Notes:
 For this parameter to take effect, a device reset is required.
 For a description of this parameter, see 'Configuring IP Network
Interfaces' on page 113.
VLAN Parameters
[EnableNTPasOAM]
Defines the application type for Network Time Protocol (NTP) services.
 [1] = OAMP (default)
 [0] = Control
Note: For this parameter to take effect, a device reset is required.
To Next Page
Loading...
Need help?
General
