66.17 Auxiliary and Configuration File Name Parameters
The configuration files (i.e., auxiliary files) can be loaded to the device using the Web
interface. For loading these files using the ini file, you need to configure these files in the ini
file and configured whether they must be stored in the non-volatile memory. The table
below lists the ini file parameters associated with these auxiliary files. For more information
on the auxiliary files, see 'Loading Auxiliary Files' on page 627.
Auxiliary and Configuration File Parameters
Parameter Description
General Parameters
[SetDefaultOnIniFileProce
ss]
Determines if all the device's parameters are set to their defaults
before processing the updated ini file.
 [0] = Disable - parameters not included in the downloaded ini file
are not returned to default settings (i.e., retain their current
settings).
 [1] = Enable (default).
Note: This parameter is applicable only for automatic HTTP update
or Web ini file upload (not applicable if the ini file is loaded using
BootP).
[SaveConfiguration]
Determines if the device's configuration (parameters and files) is
saved to flash (non-volatile memory).
 [0] = Configuration isn't saved to flash memory.
 [1] = (Default) Configuration is saved to flash memory.
Auxiliary and Configuration File Name Parameters
Web/EMS: Call Progress
Tones File
[CallProgressTonesFilena
me]
Defines the name of the file containing the Call Progress Tones
definitions. For more information on how to create and load this file,
refer to DConvert Utility User's Guide.
Note: For this parameter to take effect, a device reset is required.
Web: CAS File
EMS: Trunk Cas Table
Index
[CASFileName_x]
Defines the CAS file name (e.g., 'E_M_WinkTable.dat'), which
defines the CAS protocol (where x denotes the CAS file ID 0 to 7). It
is possible to define up to eight different CAS files by repeating this
parameter. Each CAS file can be associated with one or more of the
device's trunks, using the parameter CASTableIndex or it can be
associated per B-channel using the parameter CASChannelIndex.
Note: For this parameter to take effect, a device reset is required.
Web: Dial Plan
EMS: Dial Plan Name
[CasTrunkDialPlanName_
x]
Defines the Dial Plan name (up to 11-character strings) per trunk
(denoted by x).
Web: Dial Plan File
EMS: Dial Plan File Name
[DialPlanFileName]
Defines the name (and path) of the Dial Plan file. This file should be
created using AudioCodes DConvert utility (refer to DConvert Utility
User's Guide).
[UserInfoFileName]
Defines the name (and path) of the file containing the User
Information data.
To Next Page
Loading...
Need help?
General
