AudioCodes Media 800 MSBR User Manual

Version 6.6 665 Mediant 800 MSBR
User's Manual 52. Restoring Factory Defaults
52 Restoring Factory Defaults
You can restore the device's configuration to factory defaults using one of the following
methods:

CLI (see 'Restoring Defaults using CLI' on page 665)

Hardware reset pinhole button (see Restoring Defaults using Hardware Reset Button
on page
666)

Loading an empty ini file (see 'Restoring Defaults using an ini File' on page 666)
52.1 Restoring Defaults using CLI
The device can be restored to factory defaults using CLI, as described in the procedure
below.
 To restore factory defaults using CLI:
1. Access the CLI:
a. Connect the RS-232 serial port of the device to the communication port on your
computer. For serial cabling, refer to the Hardware Installation Manual.
b. Establish serial communication with the device using a serial communication
program (such as HyperTerminal
TM
) with the following communication port
settings:
♦ Baud Rate: 115,200 bps
♦ Data Bits: 8
♦ Parity: None
♦ Stop Bits: 1
♦ Flow Control: None
2. At the CLI prompt, type the username (default is "Admin" - case sensitive), and then
press Enter:
# Username: Admin
3. At the prompt, type the password (default is "Admin" - case sensitive), and then press
Enter:
# Password: Admin
4. At the prompt, type the following, and then press Enter:
# enable
5. At the prompt, type the password again, and then press Enter:
# Password: Admin
6. At the prompt, type the following to reset the device to default settings, and then press
Enter:
# write factory

AudioCodes Media 800 MSBR Specifications

General

Brand	AudioCodes
Model	Media 800 MSBR
Category	Network Router
Language	English