AudioCodes Media 800 MSBR User Manual

User's Manual 984 Document #: LTRT-12809
Mediant 800 MSBR
Parameter Description
"4002@10.33.4.226" (i.e., keep only four digits from right of user part):
SASRegistrationManipulation 0 = 0, 4;
Note: For a detailed description of this table, see 'Manipulating URI
user part of Incoming REGISTER' on page 510.
Web: SAS IP-to-IP Routing Table
[IP2IPRouting]
This table parameter configures the IP-to-IP Routing table for SAS
routing rules. The format of this parameter is as follows:
[IP2IPRouting]
FORMAT IP2IPRouting_Index = IP2IPRouting_SrcIPGroupID,
IP2IPRouting_SrcUsernamePrefix, IP2IPRouting_SrcHost,
IP2IPRouting_DestUsernamePrefix, IP2IPRouting_DestHost,
IP2IPRouting_DestType, IP2IPRouting_DestIPGroupID,
IP2IPRouting_DestSRDID, IP2IPRouting_DestAddress,
IP2IPRouting_DestPort, IP2IPRouting_DestTransportType,
IP2IPRouting_AltRouteOptions;
[\IP2IPRouting]
For example:
IP2IPRouting 1 = -1, *, *, *, *, 0, -1, -1, , 0, -1, 0;
Note: For a detailed description of this table parameter, see 'SAS
Routing Based on IP-to-IP Routing Table' on page 514.
66.16 IP Media Parameters
The IP media parameters are described in the table below.
IP Media Parameters
Parameter Description
Web: Number of Media
Channels
EMS: Media Channels
CLI: media-channels
[MediaChannels]
Defines the maximum number of DSP channels allocated for various
functionalities (e.g., IP conferencing, IP transcoding).
The default is 0.
Notes:
 For this parameter to take effect, a device reset is required.
 The SBC application does not require DSP channels. The SBC
application uses DSP channels only if media transcoding is
needed, where two DSP channels are used per transcoding
session.
 Other DSP channels can be used for PSTN interfaces.
Web: NetAnn
Announcement ID
[NetAnnAnncID]
Defines the NetAnn identification string (up to 16 characters) for
playing an announcement using the NetAnn interface. The application
server sends a regular SIP INVITE message with a SIP URI that
includes this identifier string and a “play=” parameter that identifies
the necessary announcement. The default is ‘annc’.
Example 1: INVITE sip: annc@10.2.3.4;play=http://localhost/1.
Example 2: INVITE sip:
annc@10.2.3.4;play=http://10.2.3.4/Annc/ello.wav.
Web: Transcoding ID
[TranscodingID]
Defines the Transcoding identification string (up to 16 characters)
used for identifying an incoming Transcoding call. The default is
‘trans’.

AudioCodes Media 800 MSBR Specifications

General

Brand	AudioCodes
Model	Media 800 MSBR
Category	Network Router
Language	English