[FaxReroutingDelay]
Defines the maximum time interval (in seconds) that the device waits
for CNG detection before re-routing calls identified as fax calls to fax
destinations (terminating fax machine).
The valid value range is 1-10. The default is 5.
Web: ENUM Resolution
CLI: enum-service-domain
[EnumService]
Defines the ENUM service for translating telephone numbers to IP
addresses or domain names (FQDN). For example, e164.arpa,
e164.customer.net, or NRENum.net.
The valid value is a string of up to 50 characters. The default is
"e164.arpa".
Note: ENUM-based routing is configured in the Outbound IP Routing
table using the "ENUM" string value as the destination address to
denote this parameter's value.
66.11.13 IP Connectivity Parameters
The IP connectivity parameters are described in the table below.
IP Connectivity Parameters
Parameter Description
Web: Enable Alt Routing
Tel to IP
EMS: Enable Alternative
Routing
CLI: alt-routing-tel2ip
[AltRoutingTel2IPEnable]
Enables the Alternative Routing feature for Tel-to-IP calls.
 [0] Disable = (Default) Disables the Alternative Routing feature.
 [1] Enable = Enables the Alternative Routing feature.
 [2] Status Only = The Alternative Routing feature is disabled, but
read-only information on the QoS of the destination IP addresses is
provided.
Web: Alt Routing Tel to IP
Mode
EMS: Alternative Routing
Mode
CLI: alt-rte-tel2ip-mode
[AltRoutingTel2IPMode]
Determines the IP Connectivity event(s) reason for triggering
Alternative Routing.
 [0] None = Alternative routing is not used.
 [1] Connectivity = Alternative routing is performed if SIP OPTIONS
message to the initial destination fails (determined according to the
AltRoutingTel2IPConnMethod parameter).
 [2] QoS = Alternative routing is performed if poor QoS is detected.
 [3] Both = (Default) Alternative routing is performed if either SIP
OPTIONS to initial destination fails, poor QoS is detected, or the
DNS host name is not resolved.
Notes:
 QoS is quantified according to delay and packet loss calculated
according to previous calls. QoS statistics are reset if no new data
is received within two minutes.
 To receive quality information (displayed in the 'Quality Status' and
'Quality Info.' fields in 'Viewing IP Connectivity' on page 691) per
destination, this parameter must be set to 2 or 3.
Web: Alt Routing Tel to IP
Connectivity Method
EMS: Alternative Routing
Telephone to IP
To Next Page
Loading...
Need help?
General
