 [1] TCP
 [2] TLS
Note: When set to [-1], the value of the SIPTransportType
parameter is used.
Web: RTCP XR Collection
Server
EMS: Esc IP
CLI: rtcp-xr-coll-srvr
[RTCPXREscIP]
Defines the IP address of the Event State Compositor (ESC). The
device sends RTCP XR reports to this server, using SIP PUBLISH
messages. The address can be configured as a numerical IP
address or as a domain name.
Web: RTCP XR Report Mode
EMS: Report Mode
CLI: rtcp-xr-rep-mode
[RTCPXRReportMode]
Determines whether RTCP XR reports are sent to the Event State
Compositor (ESC) and defines the interval at which they are sent.
 [0] Disable = (Default) RTCP XR reports are not sent to the
ESC.
 [1] End Call = RTCP XR reports are sent to the ESC at the end
of each call.
 [2] End Call & Periodic = RTCP XR reports are sent to the ESC
at the end of each call and periodically according to the
RTCPInterval parameter.
66.11 Gateway and IP-to-IP Parameters
66.11.1 Fax and Modem Parameters
The fax and modem parameters are described in the table below.
Fax and Modem Parameters
Parameter Description
Web: Fax Transport Mode
EMS: Transport Mode
CLI: fax-transport-mode
[FaxTransportMode]
Determines the fax transport mode used by the device.
 [0] Disable = transparent mode
 [1] T.38 Relay (default)
 [2] Bypass
 [3] Events Only
Note: This parameter is overridden by the parameter IsFaxUsed. If
the parameter IsFaxUsed is set to 1 (T.38 Relay) or 3 (Fax
Fallback), then FaxTransportMode is always set to 1 (T.38 relay).
EMS: V34 Transport Method
CLI: V34-fax-transport-type
[V34FaxTransportType]
Determines the V.34 fax transport method (whether V34 fax falls
back to T.30 or pass over Bypass).
 [0] = Transparent
 [1] = (Default) Relay
 [2] = Bypass
 [3] = Transparent with Events
Note: To configure V34FaxTransportType to 1 (i.e., fax relay), you
also need to configure FaxTransportMode to 1 (fax relay).
Web: V.21 Modem Transport
Type
EMS: V21 Transport
Determines the V.21 modem transport type.
 [0] Disable = (Default) Disable (Transparent)
 [2] Enable Bypass
To Next Page
Loading...
Need help?
General
