AudioCodes Media 800 MSBR User Manual

User's Manual 876 Document #: LTRT-12809
Mediant 800 MSBR
66.11.5.4 Message Waiting Indication Parameters
The message waiting indication (MWI) parameters are described in the table below.
MWI Parameters
Parameter Description
Web: Enable MWI
EMS: MWI Enable
CLI: enable-mwi
[EnableMWI]
Enables Message Waiting Indication (MWI).
 [0] Disable (default).
 [1] Enable
Notes:
 This parameter is applicable only to FXS interfaces.
 The device supports only the receipt of SIP MWI NOTIFY messages
(the device doesn't generate these messages).
 For more information on MWI, see 'Message Waiting Indication' on
page 364.
Web/EMS: MWI Analog
Lamp
CLI: mwi-analog-lamp
[MWIAnalogLamp]
Enables the visual display of MWI.
 [0] Disable (default).
 [1] Enable = Enables visual MWI by supplying line voltage of
approximately 100 VDC to activate the phone's lamp.
Notes:
 This parameter is applicable only for FXS interfaces.
 This parameter can also be configured in a Tel Profile.
Web/EMS: MWI Display
CLI: enable-mwi
[MWIDisplay]
Enables sending MWI information to the phone display.
 [0] Disable = (Default) MWI information isn't sent to display.
 [1] Enable = The device generates an MWI message (determined by
the parameter CallerIDType), which is displayed on the MWI display.
Note:
 This parameter is applicable only to FXS interfaces.
 This parameter can also be configured in a Tel Profile.
Web: Subscribe to MWI
EMS: Enable MWI
Subscription
CLI: subscribe-to-mwi
[EnableMWISubscripti
on]
Enables subscription to an MWI server.
 [0] No (default)
 [1] Yes
Notes:
 To configure the MWI server address, use the MWIServerIP
parameter.
 To configure whether the device subscribes per endpoint or per the
entire device, use the parameter SubscriptionMode.
Web: MWI Server IP
Address
EMS: MWI Server IP
CLI: mwi-srvr-ip-addr
[MWIServerIP]
Defines the MWI server's IP address. If provided, the device subscribes to
this IP address. The MWI server address can be configured as a
numerical IP address or as a domain name. If not configured, the Proxy
IP address is used instead.
Web/EMS: MWI Server
Transport Type
CLI: mwi-srvr-transp-
type
[MWIServerTransportT
ype]
Determines the transport layer used for outgoing SIP dialogs initiated by
the device to the MWI server.
 [-1] Not Configured (default)
 [0] UDP
 [1] TCP

AudioCodes Media 800 MSBR Specifications

General

Brand	AudioCodes
Model	Media 800 MSBR
Category	Network Router
Language	English