Where:
 Index = Port number (where 0 is Port 1)
 PortEnable = enables [1] or disables [0] IEEE 802.3af-2003 PoE
 PortPower = defines maximum power consumption
Note: For a description of this parameter, see 'Configuring Power over
Ethernet' on page 109.
66.2 Management Parameters
This subsection describes the device's Web and Telnet parameters.
66.2.1 General Parameters
The general management parameters are described in the table below.
General Management Parameters
Parameter Description
WAN OAMP Interface
CLI: bind GigabitEthernet
<slot/port.vlanId> oamp
[OAMPWanInterfaceNa
me]
Binds the OAMP interface to a WAN interface, which can later be
associated with a Virtual Routing and Forwarding (VRF).
Web: Allow WAN access
to HTTP
CLI: wan-http-allow
[AllowWanHTTP]
Enables WAN access to the management interface through HTTP.
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: Allow WAN access
to HTTPS
CLI: wan-https-allow
[AllowWanHTTPS]
Enables WAN access to the management interface through HTTPS.
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: Allow WAN access
to SNMP
CLI: wan-snmp-allow
[AllowWanSNMP]
Enables WAN access to the management interface through SNMP.
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: Allow WAN access
to Telnet
CLI: wan-telnet-allow
[AllowWanTelnet
Enables WAN access to the management interface through Telnet.
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
Web: Allow WAN access
to SSH
CLI: wan-ssh-allow
[AllowWanSSH]
Enables WAN access to the management interface through SSH.
 [0] Disable (default)
 [1] Enable
Note: For this parameter to take effect, a device reset is required.
To Next Page
Loading...
Need help?
General
