SIP User's Manual 160 Document #: LTRT-12801
MP-500 MSBG
Parameter Description
Contact User
[Account_ContactUser]
Defines the AOR user name. It appears in REGISTER From/To
headers as ContactUser@HostName, and in INVITE/200 OK
Contact headers as ContactUser@<device's IP address>. If not
configured, the 'Contact User' parameter from the 'IP Group Table'
page is used instead.
Note: If registration fails, then the user part in the INVITE Contact
header contains the source party number.
Application Type
[Account_ApplicationType]
Defines the application type:
 [0] GW/IP2IP = Gateway and IP-to-IP application (default)
 [2] SBC = SBC application
3.4.5.5 Coders and Profile Definitions
The Coders And Profile Definitions submenu includes the following page items:
îš„ Coders (refer to ''Configuring Coders'' on page 161)
îš„ Cod
er Group Settings (refer to ''Configuring Coder Groups'' on page 162)
îš„ Tel Profile Se
ttings (refer to ''Configuring Tel Profiles'' on page 164)
îš„ IP Profile Settings (refe
r to ''Configuring IP Profiles'' on page 166)
Implementin
g the device's Profile features, provides the device with high-level adaptation
when connected to a variety of equipment (at both Tel and IP sides) and protocols, each of
which requires different system behavior.
You can assign different Profiles (behavior) per call, using the call routing tables:
îš„ 'Tel to IP Routing' page (refer to ''Configuring the Tel to IP Routing Table'' on page
201)
îš„ 'IP to Hunt Group Routing'
page (refer to ''Configuring the IP to Trunk Group Routing''
on page 206)
In addition, you ca
n associate different Profiles per the device's channels.
Each Profile contains a set of parameters such as coders, T.38 Relay, Voice and DTMF
Gain, Silence Suppression, Echo Canceler, RTP DiffServ, Current Disconnect and more.
The Profiles feature allows you to customize these parameters or turn them on or off, per
source or destination routing and/or per the device's endpoints (channels). For example,
specific ports can be assigned a Profile that always uses G.711.
To Next Page
Loading...
Need help?
General
