SIP User's Manual 294 Document #: LTRT-12801
MP-500 MSBG
Parameter Description
[EnableNTPasOAM]
This parameter applies to both Multiple IPs and VLAN
mechanisms.
Multiple IPs: Determines the network type for NTP services.
VLAN: Determines the traffic type for NTP services.
 [1] = OAMP (default)
 [0] = Control.
Note: For this parameter to take effect, a device reset is
required.
[VLANSendNonTaggedOnNative]
Specify whether to send non-tagged packets on the native
VLAN.
 [0] = Sends priority tag packets (default).
 [1] = Sends regular packets (with no VLAN tag).
Note: For this parameter to take effect, a device reset is
required.
6.1.3 Static Routing Parameters
The static routing parameters are described in the table below.
Table 6-3: Static Routing Parameters
Parameter Description
Static IP Routing Table Parameters
You can define up to 50 static IP routing rules for the device. For example, you can define static
routing rules for the OAMP and Control networks, since a default gateway is supported only for the
Media traffic network. Before sending an IP packet, the device searches this table for an entry that
matches the requested destination host/network. If such an entry is found, the device sends the
packet to the indicated router. If no explicit entry is found, the packet is sent to the default gateway
(configured in the 'Multiple Interface' table).
The IP routing ini file parameters are array parameters. Each parameter configures a specific column
in the IP Routing table. The first entry in each parameter refers to the first row in the IP Routing table,
the second entry to the second row, and so on. In the following example, two rows are configured
when the device is in network 10.31.x.x:
RoutingTableDestinationsColumn = 130.33.4.6, 83.4.87.6
RoutingTableDestinationMasksColumn = 255.255.255.255, 255.255.255.0
RoutingTableGatewaysColumn = 10.31.0.1, 10.31.0.112
RoutingTableInterfacesColumn = 0, 1
RoutingTableHopsCountColumn = 20, 20
Web: Destination IP Address
EMS: Destination IP
[RoutingTableDestinationsColumn]
Specifies the IP address of the destination host /
network.
Note: For this parameter to take effect, a device reset
is required.
Web: Destination Mask
EMS: Prefix Length
[RoutingTableDestinationMasksColumn]
Specifies the subnet mask of the destination host /
network.
Note: For this parameter to take effect, a device reset
is required.
To Next Page
Loading...
Need help?
General
