Version 5.8 409 October 2009
SIP User's Manual 6. Configuration Parameters Reference
6.15 Hunt Groups, Number Manipulation and Routing
Parameters
This subsection describes the device's number manipulation and routing parameters.
6.15.1 Hunt Groups and Routing Parameters
The Hunt Groups and routing parameters are described in the table below.
Table 6-50: Hunt Groups and Routing Parameters
Parameter Description
Web: Hunt Table
EMS: SIP Endpoints > Phones
[TrunkGroup]
This ini file table parameter is used to define and activate the
device's endpoints, define telephone numbers for them, and
assign them to Hunt Group IDs. The format of this parameter is
shown below:
[TrunkGroup]
FORMAT TrunkGroup_Index = TrunkGroup_TrunkGroupNum,
TrunkGroup_FirstTrunkId, TrunkGroup_FirstBChannel,
TrunkGroup_LastBChannel, TrunkGroup_FirstPhoneNumber,
TrunkGroup_ProfileId, TrunkGroup_LastTrunkId,
TrunkGroup_Module;
[\TrunkGroup]
For example:
TrunkGroup 0 = 0, 255, 1, 4, 2000, 0, 255, 1;
TrunkGroup 1 = 0, 255, 2, 2, 102, 1, 255, 1;
Notes:
 The first entry in this table starts at index 0.
 This parameter can appear up to four times per module.
 Each endpoint (i.e., channel) must be assigned a unique
phone number. In other words, no two endpoints can have
the same phone number.
 For configuring this table in the Web interface, refer to .
 For a description of ini file table parameters, refer to ''Format
of ini File Table Parameters'' on page 273.
To Next Page
Loading...
Need help?
General
